Wolverine Airsoft 18″ Wire Harness - Gen. 2
The Wolverine Airsoft 18″ Wire Harness is an original replacement wiring harness for compatible Wolverine Gen. 2 HPA systems. Its approximately 457 mm length provides room to route the wiring through the replica and position the connected electronics where the build allows. It is a practical replacement when the original cable or its connectors have been damaged.
18″ Length for Flexible Routing
The longer harness gives more freedom when planning the cable route around the replica’s internal components. This can be useful in a build where a shorter harness would limit the available position of the control electronics.
Its plug-ended arrangement follows the compatible Wolverine system’s wiring layout. Using the correct replacement harness keeps the connector arrangement consistent with that system when replacing a damaged cable.
Choose the Correct Generation
This is the Gen. 2 harness identified by product code MLT-E-007-GEN2. Match the model, connector layout and generation to the existing installation before purchasing; the 18″ measurement alone does not determine compatibility.
Route the cable with enough clearance for the gearbox shell, stock and other moving or removable parts. Avoid pinching the wires or pulling on the connectors, and check that the available length suits the planned installation.
Technical Specifications
- Manufacturer: Wolverine Airsoft
- Product type: Replacement wire harness
- Version: Gen. 2
- Length: 18″ / approximately 457 mm
- Compatibility: Compatible Wolverine Gen. 2 HPA systems with the matching connector layout
- Manufacturer product code: MLT-E-007-GEN2-SKU
